→		→
Step1:Drill the anchoring parts (1)Mark the drilling positions on the wall according to board size (2)Drill into the wall to install our supplied anchoring parts		Step2:Apply mortar (1)Spread our cement mortar evenly on the wall surface and the back of the board (2)Ensure proper thickness for full adhesion		Step3:Insert boards into anchoring parts and attach to wall (1)Place the board into the pre-installed anchoring parts (2)Check that the board is level and flush
				↓
	←		←
Step6:Fill joints with foam strips (1)Insert our foam strips into the gaps between boards (2)Apply masking paper along the edges to prevent mortar or sealant contamination		Step5:Repeat steps 2–4 Continue with the next boards, maintaining vertical alignment and flatness		Step4:Install top anchoring parts Drill and secure the top part of the board for stability
↓
	→
Step7:Apply sealant (1)Fill the joints with our high-quality sealant  (2)Ensure joints are sealed and watertight		Step7:Apply sealant (1)Fill the joints with our high-quality sealant  (2)Ensure joints are sealed and watertight

(2)Installation on Tiled Walls

• Check tile adhesion:
  • Loose tiles → Remove tiles and build a new cement wall
  • Stable tiles → Apply a primer/sealer
• Follow the new wall installation process

  (3)Installation on Coated Walls

• Build a new cement wall first
• Follow the new wall installation process with our complete set of materials

3. Tips for a Successful Installation

• Ensure each board is level and vertical before fixing
• Clean excess mortar and sealant immediately during installation
• Foam strips should match joint sizes for effective sealing
• Avoid over-applying sealant to maintain a neat finish
• Using our supplied kit (anchoring parts, mortar, foam strips, sealant and others) simplifies installation and ensures high-quality results