
(1)Foamed Ceramic Panel
(2)Anchoring parts
provide mechanical fixation for foamed ceramic boards
(3)primer/sealer
enhances bonding between the base wall and mortar(for ceramic tile walls only)
(4)Cement Mortar
provide bonding between foamed ceramic boards and base wall
(5)Electric drill and drill bits
Used to drill in screws for anchoring parts
(6)Foam Strips
for joint filling between foamed ceramic panels
(7)Sealant
for joint filling between foamed ceramic panels
(8)Masking Paper
protects board edges and surfaces during installation
Step1:Drill the anchoring parts
(1)Mark the drilling positions on the wall according to board size
(2)Drill into the wall to install our supplied anchoring parts
Step2:Apply mortar
(1)Spread our cement mortar evenly on the wall surface and the back of the board
(2)Ensure proper thickness for full adhesion
Step3:Insert boards into anchoring parts and attach to wall
(1)Place the board into the pre-installed anchoring parts
(2)Check that the board is level and flush
Step6:Fill joints with foam strips
(1)Insert our foam strips into the gaps between boards
(2)Apply masking paper along the edges to prevent mortar or sealant contamination
Step5:Repeat steps 2–4
Continue with the next boards, maintaining vertical alignment and flatness
Step4:Install top anchoring parts
Drill and secure the top part of the board for stability
Step7:Apply sealant
(1)Fill the joints with our high-quality sealant
(2)Ensure joints are sealed and watertight
Step8:Remove masking paper
(1)After the sealant partially cures, remove the masking paper
(2)Installation is complete