Marble Pattern 30mm Class A1 Fire Performance Ceramic Insulation Panel for Suspended Soffit Panel Ceilings

In short: Marble pattern glazed ceramic insulation panel, 30 mm at 7.5 kg/m², Class A1, for suspended soffits and interior ceilings.

A stone ceiling is usually ruled out by weight and by the risk of a panel dropping. This marble pattern sintered ceramic soffit insulation panel is 30 mm thick at about 7.5 kg/m², Class A1, and is carried on a standard concealed grid, so the look of stone is available overhead without the structural penalty.

The panel is fired flat and held to a 1 mm tolerance, which keeps the ceiling plane even under grazing light. The marble vein is in the body, so it can be book matched across a raft and it will not peel in the warm, dry air layer near a ceiling.

• Class A1 Fire Performance: This marble pattern glazed ceramic insulation panel 30 mm suspended soffit panel is non-combustible from surface to core to GB 8624, with no dripping, no heavy smoke and no toxic gas release, which suits suspended interior ceilings and soffits in public and commercial buildings.
• Fired-in Marble Pattern: The veined marble ceiling face is generated in the body at 1200 °C, so it does not peel, chalk or fade like a printed or coated surface.
• Low Dead Load: About 7.5 kg/m² at 30 mm, roughly one quarter of a 30 mm marble slab, which keeps anchors, keel steel and crane time down.
• Stable Colour Lot to Lot: A fixed pigment recipe and firing curve hold the veined marble ceiling face inside the approved tolerance on repeat orders.
• Weather and Pollution Resistance: Closed cells and a sintered skin resist water penetration, 25 freeze-thaw cycles and urban staining; cleaning needs water, not chemical stone restorers.
• Fired Flat for a True Ceiling Plane: 1 mm flatness tolerance and a concealed grid keep the ceiling plane even where light washes across it at a shallow angle.

• Airport and metro station ceiling rafts
• Hotel lobby and ballroom ceilings
• Office reception and corridor soffits
• Retail mall ceiling features
• Museum and gallery soffit insulation panels

Use a concealed carrier grid with safety clips and a secondary retention wire per panel. For rafts and feature ceilings we supply a layout with book matched vein direction marked on each piece.

The marble pattern glazed ceramic insulation panel 30 mm suspended soffit panel is supplied on plywood pallets with PE film, corner protection and edge guards, about 1.2 tons per pallet, loaded into 20 ft or 40 ft containers with fumigation-free packing. Store under cover, keep pallets level and avoid point loads on the decorated face. Special sizes, corner pieces and window returns can be produced to drawing.