SANDSTONE Natural Sandstone Look A1 Ceramic Foam Insulation Panels for Exterior Walls

The SANDSTONE ceramic foam insulation board brings a natural sandstone appearance to exterior walls while delivering the functional performance of foamed ceramic. Each 600×600×25 mm board is fired from inorganic raw materials, so the panel is non-combustible, dimensionally stable, and free from organic binders that age under ultraviolet light.

Because the board combines a decorative sandstone face with a porous insulating core, one material replaces the traditional build-up of render, insulation, and stone veneer. That shorter chain of trades reduces fixing points, site labour, and the risk of delamination on facade projects where appearance and thermal performance must both hold for decades.

• Natural sandstone surface with fine mineral grain and matte sheen
• Class A1 non-combustible inorganic body tested to GB 8624
• Lightweight porous structure keeps wall dead load low
• Thermal insulation reduces heat transfer through the building envelope
• Water absorption of 0.6% keeps performance stable in wet weather
• Integrated insulation and decoration in a single 25 mm board

• Exterior wall insulation and decoration on new buildings
• Building facades with stone design intent
• Architectural decorative systems and feature walls
• Renovation of rendered walls in residential projects

Fixing follows a simple sequence: set out from a datum line, fix the base rail, then bond or mechanically fasten each 600×600 mm sandstone ceramic foam insulation board to a levelled substrate. Because the panel is 25 mm thick and weighs about 10 kg/m², two installers can position boards by hand, check alignment with a straight edge, and finish joints the same day. Movement joints are placed at floor lines and at intervals recommended for the substrate, so thermal movement never transfers into the sandstone face.

Boards are stacked face to face on timber pallets, corner protected and strapped, with batch certificates placed inside each pallet so the site team can match panels to the approved data sheet on delivery.

MYREAL has supplied developers, consultants, cost engineers, design institutes, contractors, EPCs, and distributors since 2014, working from a manufacturing network with experienced technical teams. Every batch is checked against GB 8624, GB 6566, and GB/T 5486 before shipment, so the sandstone ceramic foam insulation board you receive matches the specification you approved. Tell us your board size, thickness, colour direction, and project quantity, and our engineers will confirm a tailored offer with samples.