PURE COLOUR Lightweight Solid Color Ceramic Foam Panels for Curtain Wall Cladding Use

At 380 kg/m³ and 20 mm thick, this PURE COLOUR panel weighs around 7.6 kg per square metre. On a facade with a fixed structural allowance, that low weight can decide whether a stone look or a coloured panel scheme is buildable at all.

The colour is fired into the body rather than applied as a film, so the panel can be cut and drilled on site without exposing a raw edge. Thin sections, uniform colour and low mass together make this the practical option for over cladding and light curtain wall systems.

Low weight does not mean low durability. The 20 mm body absorbs only 0.6% water, resists frost cycling and keeps its colour because the pigment sits inside the fired ceramic rather than in a surface film that can chalk or peel under ultraviolet light.

• Low 380 kg/m³ density reduces facade dead load
• 20 mm slim profile is easy to handle on site
• Uniform colour that continues through the cut edge
• Class A1 non-combustible inorganic ceramic body
• Water absorption of 0.6% for long-term stability
• Custom colours available for project palettes

• Curtain wall cladding with limited load capacity
• Facade retrofit and over cladding
• Canopies and soffits in a single colour
• Interior wall linings in commercial fit-out

Panels are bonded to a levelled substrate with adhesive ribs and secured at the perimeter where the specification requires mechanical restraint. Two installers can handle the 800 x 400 mm units comfortably, which keeps scaffold time short and lets the colour field close quickly.

Pallets are corner protected, strapped and shrink wrapped, with each pallet labelled by colour code and quantity so panels can be distributed floor by floor.

MYREAL has supplied developers, consultants, cost engineers, design institutes, contractors, EPCs and distributors since 2014. Colour panels are fired in controlled batches and checked against the retained master sample, so the lightweight pure colour ceramic foam panel you receive keeps the same tone as the chip you approved. Share your colour reference, board size and project quantity, and our engineers will confirm a tailored offer with samples.